High performance water reducing agent XNHPWA-600高性能減水劑

Products > High performance water reducing agent XNHPWA-600高性能減水劑

High performance water reducing agent XNHPWA-600高性能減水劑

 Product introduction  産品簡介  

     XNHPWA-600 high performance water reducing agent is the third generation high performance water reducing agent,which is currently high-efficiency water-reducing agent with the highest scientific and technological content, the best application prospect and the best comprehensive performance in the world.
     It has the advantages of low dosage,high water reducing rate,good cement adaptability,small slump loss and strong durability,etc.  It is a non-toxic, non-corrosive, non-combustible safe high-performance water-reducing agent.
     Compared with the performance of similar products from China and abroad, XNHPWA-600 high-performance water reducing agent has reached the current international advanced level in terms of technical performance indicators and cost performance.
    XNHPWA-600高性能減水劑是第三代高性能減水劑,是目前世界上科技含量最高、應用前景最好、綜合性能最優的一種高效減水劑。具有摻量低、減水率高、水泥适應性好、坍落度損失小、耐久性強等優點,是一種無毒、無腐蝕、不燃燒的安全環保型高性能減水劑。與國内外同類産品性能比較,XNHPWA-600高性能減水劑在技術性能指标、性價比方面都達到了當今國際先進水平。



Main performance  主要性能

Project

項  目

Performance

性能指标

Water reduction rate

減水率(%)
≥25

Bleeding rate ratio

 泌水率比(%)
≤60

Solid content

含固量(%)
≥15.0

Air content

含氣量(%)
≤6.0

Density

密度(g/cm3)
1.04±0.02

Total alkali

總堿量(%)
≤10

Chloride ion content

氯離子含量(%)
≤0.1

PH value

PH值
6.0±2.0

Difference in solidification

time

凝結時間之差(min)

Initial

solidification

初凝
-90~+120

Final solidifica

終凝

1h change over time

1h經時變化量

Slump

坍落度/min
≤80

Air content

含氣量/%

Compressive strength ratio

 抗壓強度比(%)
1d≥170
3d≥160
7d≥150
28d≥140

Shrinkage ratio

收縮率比(%)
28d≤110

Relative durability(200 times)

相對耐久性(200次)(%)


Scope of application  适用範圍

    XNHPWA-600 high-performance water reducing agent is suitable for configuring high, medium and low grade concrete, and also suitable for configuring various types of precast, pumping, long-distance transportation, self-flowing and other performance requirements. 
  XNHPWA-600高性能減水劑适用于配置高、中、低各類标号混凝土,也适宜配置各類預制、泵送、長距離運輸,自流态等各種性能要求的混凝土。

 

Precautions for use 使用注意事項

1、The content of this product (solid content 20%) is 0.6% to 2.0% of the total weight of the cementitious material. The usual dosage is 0.8%~1.5%. Before use, a trial mix test of concrete should be carried out to find the best mixing amount.
   本産品(固含量20%)的摻量爲膠凝材料總重量的0.6%~2.0%。常用摻量爲0.8%~1.5%。使用前應進行混凝土試配試驗,以求最佳摻量。

2、This product can be mixed directly with the cement into the mixer, or first add 40-70% concrete mixing water, and then add this product, the effect is better.
   本産品可随水泥加入攪拌機直接攪拌,或先加40~70%砼拌和水,再加入本品,效果更佳。

3、This product should not be mixed with other water reducing agents. Before using this product, the storage tanks, mixers and mixer trucks that have used other water reducing agents must be rinsed, otherwise the water reducing effect may be affected.
   本産品不得與其它減水劑混合使用。使用本産品前必須将使用過其它減水劑的儲罐、攪拌機和攪拌車沖洗幹淨,否則有可能會影響減水效果。


4、When using this product, the measurement must be accurate and the concrete must be mixed evenly. Excessive addition of additives or uneven mixing may cause segregation of bleeding and difficulty in pumping.
   使用本産品時,必須計量準确,混凝土必須攪拌均勻。加入超量外加劑或攪拌不均勻可能導緻離析泌水、泵送困難等現象。

5、Because this product has the characteristics of high water reduction rate, the slump is highly sensitive to water consumption, and water consumption must be strictly controlled when using it.
    由于本産品具有高減水率的特點,因此坍落度對用水量的敏感性較高,使用時必須嚴格控制用水量。


Packaging and storage 包裝與貯存

1、This product is liquid and is packed in 1000kg plastic drums or plastic bags.
   本産品爲液劑,采用1000kg塑料桶裝或200±1kg塑料桶包裝。

2、Should be placed in a cool, dry place, sealed storage away from direct sunlight, rain or negative temperature environment preservation.
   應置于陰涼、幹燥處儲存,避免陽光直射、雨淋或負溫環境保存。

3、The warranty period is one year, and the overdue products can only be used after being tested and verified.
   質保期一年,超期産品經試驗驗證合格後仍可繼續使用。